the required route is not in the routing table B. There are two routes in the routing table: 0 dst-addr=10.1.1.0/24 gateway=5.5.5.5 1 dst-addr=10.1.1.4/30 gateway=5.6.6.6 Which gateway will be used to get to the IP address 10.1.1.6? A. The default value of \'target-scope\' for a static route is: … 2/125Ī. What is the maximum number of supported VLANs on a single ethernet interface in RouterOS: A. Router needs to send packets to 192.168.3.240. ip route configuration on router, /ip /ip /ip /ip In case of failure of the gateway, routes pointing to that gateway will become inactive 12. Gateway is checked every 10 seconds and after 2 failures, the gateway is considered unreacheable D. Gateway is checked every 10 seconds and after a single failure, the gateway is considered unreacheable C. Check gateway option can be configured for Ping, ARP and RARP (reverse ARP) B. The 'check-gateway' option is enabled for one route. When sending out an ARP request, an IP host is expecting what kind of address for an answer? A. What is the maximum number of hops, after which the network will be considered unreachable in OSPF? A. He should use "netwatch" to trigger static routes whenever OSPF fails 9. He should manually disable the static routes and enable them whenever OSPF fails D. Delete all static routes because there is no way for it to work with OSPF C. He should increase the administrative distance of the static route B. What can be done to make the static route work as a failover whenever the dynamic routing protocol fails.
But realized that he has a static route on the routers. A MikroTik system administrator implemented OSPF Routing protocol in the network. Which gateway will be used for a packet with destination address 10.1.5.126? A. The route distributed as type 2 will be the preferred one 7. The route distributed as type 1 will be the preferred one D. Traffic to Internet will be load-balanced between the two routes as routes from both routers will be installed in routing tables C. RouterOS relies only on cost, so route from the closest router in term of cost will be chosen B.
MikroTik RouterOS does not distinguish types when redistributing default route. What will be preferred gateway in the network? A. One does it as type 1, the other as type 2, cost configuration is the same on both routers. Both of them have OSPF routing enabled and are redistributing their default gateways to the network respectively. There are two gateways to the Internet in a network on two separate routers.
ip route add dst-address=0.0.0.0/0 gateway=Ether1 D.
Assuming that all the necessary configuration has already been done on R2 (proxy-arp is disabled), to communicate from a device on LAN1 to a device on LAN2, which of the following configurations on R1 would enable this? A. Which type of ip route is the highest priority for routing decision ? A. The following command was issued: > routing ospf route print # DST-ADDRESS STATE COST GATEWAY INTERFACE 0 10.0.0.0/30 inter-area 10 172.16.0.1 ether1 1 10.0.0.0/30 inter-area 20 172.16.0.2 ether2 2 10.0.0.0/30 intra-area 30 172.16.0.3 ether3 3 10.0.0.0/30 intra-area 40 172.16.0.4 ether4 Assuming that elsewhere there are no problems, which gateway will be installed into the routing table as 'active'? A. Each packet can only have one routing mark. To assign specific traffic to a route - traffic must be identified by a routing mark.
0 kommentar(er)
